Direct Color Systems Directjet 1024UV Información técnica descargar pdf (Pagina 26)

Maintenance

Go to table of contents

DCS_Direct_Jet_1024UVHS_Maintenance_Troubleshooting_Guide_1.2.docx 26 | Page

UV Lamp Height Adjustment

Always check the head height

before the UV lamp height!

If you have performed and are satisfied with the

head height adjustment, place two shims on the

media table in front of the UV lamp.

Press and hold then use the arrow keys to move the media table so the shims

are under the lamp. The lamp should be only slightly above the shims (enough so that a

piece of copier paper can fit).

If the lamp is not at the right height, hold the

lamp and use the hex tools to first loosen the set

screw and then the lamp screw. Do not let the

lamp slide on its own. Move the lamp so that it is

at the proper height then tighten the lamp screw

and then the set screw.

Lamp screw

Set screw

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 52 53

Sin comentarios

Direct Color Systems Directjet 1024UV Información técnica Pagina 26